Heretic
Resource contributor
- Messages
- 6,830
- Country

I've got an autopilot on a gauge poly in a virtual cockpit and it looks just fine (i.e. the gauge shows up as expected), except that I can only click it from a very specific view angle.
It's not the gauge that acts up as it works fine on the 2D panel.
There's no visible z-fighting going on between the autopilot panel base poly, the autopilot base poly and the autopilot gauge poly in FS9/X.
All are separated by one mm in GMax.
Any ideas?
It's not the gauge that acts up as it works fine on the 2D panel.
There's no visible z-fighting going on between the autopilot panel base poly, the autopilot base poly and the autopilot gauge poly in FS9/X.
All are separated by one mm in GMax.
Any ideas?
