Hi guys me again.
Although the technical aspects of id'ing GenX scenery BGL's totally escapes me I am never the less pressing on with the few airfields I have been able to find.
These are near the coast and as such are more easily found unlike those inland.
I have had success in placing autogen trees but it is a bit hit and miss as to whether they actually appear.
I have read Luis Féliz-Tirado's instructions and have added the following to my cfg under Terrain
IMAGE_PIXELS_FOR_AUTOGEN_POLYGONS=1024
However I see no difference anywhere so do not understand this bit.
I have also set my autogen density to 30
It seems that the larger I draw my polygon (Polygon Region) the more trees appear however if I draw a narrow strip nothing appears. Now I understand (vaguely) that this has something to with how FSX samples "things".
I am using the Groupings as opposed to the Regionalizations.
Is there some way in which I can increase the number of trees that appear in a smallish polygon.
Any help on how to increase the number of trees in any given size polygon would be appreciated.
I also have to bear in mind that I shall be passing my results onto friends.
Regards
Richard
PS One more question and that is I can delete ALL of my polygons by selecting Polygon Regions and pressing delete but of course that deletes them all.
How can I delete just one polygon to be able to just redraw that one?
R
Later.
As you may remember I have using Instant Scenery placed many trees at my locations.
I have just run an experiment where I disabled my IS Tree BGl and low and behold my autogen trees appear even in narrow strips.
When I enable my IS trees the autogen ones, some but not all, disappear.
Now I guess there must be some madly complicated explanation for this.
Would my choice of tree play any part in this?
I have been using Forest Broadleaf and Forest Broadleaf 3-15m Short.
In the above I used Oak1 6-40m ALL (no Oldgrowth).
R
Although the technical aspects of id'ing GenX scenery BGL's totally escapes me I am never the less pressing on with the few airfields I have been able to find.
These are near the coast and as such are more easily found unlike those inland.
I have had success in placing autogen trees but it is a bit hit and miss as to whether they actually appear.
I have read Luis Féliz-Tirado's instructions and have added the following to my cfg under Terrain
IMAGE_PIXELS_FOR_AUTOGEN_POLYGONS=1024
However I see no difference anywhere so do not understand this bit.
I have also set my autogen density to 30
It seems that the larger I draw my polygon (Polygon Region) the more trees appear however if I draw a narrow strip nothing appears. Now I understand (vaguely) that this has something to with how FSX samples "things".
I am using the Groupings as opposed to the Regionalizations.
Is there some way in which I can increase the number of trees that appear in a smallish polygon.
Any help on how to increase the number of trees in any given size polygon would be appreciated.
I also have to bear in mind that I shall be passing my results onto friends.
Regards
Richard
PS One more question and that is I can delete ALL of my polygons by selecting Polygon Regions and pressing delete but of course that deletes them all.
How can I delete just one polygon to be able to just redraw that one?
R
Later.
As you may remember I have using Instant Scenery placed many trees at my locations.
I have just run an experiment where I disabled my IS Tree BGl and low and behold my autogen trees appear even in narrow strips.
When I enable my IS trees the autogen ones, some but not all, disappear.
Now I guess there must be some madly complicated explanation for this.
Would my choice of tree play any part in this?
I have been using Forest Broadleaf and Forest Broadleaf 3-15m Short.
In the above I used Oak1 6-40m ALL (no Oldgrowth).
R
Last edited:




