• Which the release of FS2020 we see an explosition of activity on the forun and of course we are very happy to see this. But having all questions about FS2020 in one forum becomes a bit messy. So therefore we would like to ask you all to use the following guidelines when posting your questions:

    • Tag FS2020 specific questions with the MSFS2020 tag.
    • Questions about making 3D assets can be posted in the 3D asset design forum. Either post them in the subforum of the modelling tool you use or in the general forum if they are general.
    • Questions about aircraft design can be posted in the Aircraft design forum
    • Questions about airport design can be posted in the FS2020 airport design forum. Once airport development tools have been updated for FS2020 you can post tool speciifc questions in the subforums of those tools as well of course.
    • Questions about terrain design can be posted in the FS2020 terrain design forum.
    • Questions about SimConnect can be posted in the SimConnect forum.

    Any other question that is not specific to an aspect of development or tool can be posted in the General chat forum.

    By following these guidelines we make sure that the forums remain easy to read for everybody and also that the right people can find your post to answer it.

Welding problem!

mskhan1991

mskhan1991

Resource contributor
Messages
935
Country
pakistan
Hi guys check the picture below.

I am having a problem that when I weld a spline's 2 vertices (shown in circle in the picture below), the curved edges change from the red path to the blue path as drawn in the picture, so basically the shape is de-shaped when I weld certain vertices. any solutions to this problem?
 
Last edited:
have you looked at the type of vertex that is assigned? You may just need to change the vertex in the circle to a bezier or bezier corner to give you the control needed to establish the desired shape with the desired number of vertices.
 
have you looked at the type of vertex that is assigned? You may just need to change the vertex in the circle to a bezier or bezier corner to give you the control needed to establish the desired shape with the desired number of vertices.
Click to expand...

how do I do that?
 
You must log in or register to reply here.
Back
Top